![]() If my budget is much higher, I'll consider a Direct Drive Wheel (OSW), they may be offered as plug & play by the time I'm ready. ( Is there a Thrustmaster office in Australia? Have you had an issue with warranty claims in Aus?). (Logitech pedals are reportedly better, also no shifter included). When I eventually replace my G27, I'll consider a Thrustmaster T300. ![]() ![]() My Logitech_G27 page is loaded with information and related links. I'd suggest Logitech's G27 if available, you should save money and the shifter included too. The G29 may be compatible in ps3 mode, but The release version of the wheel reportedly uses the same drivers as the G920.ĭavid had not been able to test a release version of the wheel when I made this update.įollowing content which has been struck out may be inaccurate or at least unknown.ĭavid said: "Basically because the G29 I had used different firmware and possibly electronics then any comparison between the feel or behavior of the three wheels are suspect at best".Īlso noted "Neither may be compatible with linux/mac it is hard to say without (If you are windows savvy, run joy.cpl, it appears to land in same place).ĭavid's G29 has been identified as a pre-production model that used the G27 firmware and drivers.ĭavid was not aware he was testing a pre-production model.Īs David said, "I'm sorry for misleading anyone!" Open windows program list > type in search box: games controllers > open set up usb game controllers > select wheel > properties > settings > calibrate. To calibrate his G29 in windows 7 to work in other games, he calibrated in 'set up usb game controllers'. Calibrate wheel in Windows to work in other games - reported by GPC:.A member's comparison between G29 & T300RS post (read the rest of the thread too).New Page: G29 review by iRacing member Steve C.Shifter not included AUD79.95Īussies: 10/2015 Harvey Norman & Dick Smith reportedly had specials priced under $300 online. Prices (when I checked) links above: AUD499 wheel and pedals only. You can map that to the up/down buttons in the black box (or brake bias, etc) and it will allow you to modify a value by spinning the knob." "What does the rotary dial do? The dial sends out a series of button presses, one set when turning left, another when turning right."Anything about using the shifter? The g27 shifter works out of the box, but the buttons do nothing, the G25 shifter can be used with an adapter (I think, I did not test it)".Sensor like the Thrustmaster and Fanatec wheels. "Does the wheel have an encoder like the G27? I believe it uses a hall effect.The G27 only allows the d-pad to go left or down at once, so only one button can be held down (there are 4 buttons under the dpad), now you can press left and down together holding down both buttons at once. Unlike the G27, the d-pad on G29 and G920 wheels can be pressed left and down at the same time.G29 pedals may or may not need to be depressed once to calibrate - yet to confirm.Yet to confirm, G29 pedals may be 12 bit (0-4095) G29 pedals may have a higher resolution than G27 pedals.12 is a good starting point.Īlso read F9 - FFB AUTO STRENGTH SETTING on FFB page. Set the force slider in-sim between 8 and 20 depending on car and track.Set damping in-sim between 10 and 15% (see notes on Logitech G27 and FFB pages). ![]() He also suggests his force map file (Wheel Profile note on G27 page - ) will have little impact.Ī friend using a Wheel Profile does like it better.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |